Thingiverse
Z Stabilizer for Tornado/CR-10/... (608ZZ bearing) by cbaoth
by Thingiverse
Last crawled date: 4 years, 7 months ago
This is a quick remix of TomExplorador's (LESS PARTS!) Frame Braces Titian & Creality CR-10 & ANET). I personally use it on my Tevo Tornado but since I didn't change the dimensions, it should fit CR-10 etc. as mentioned in the original version.
Support_CR-10_No_Z_Thread.stl: Without Z-rod / bearing. Intended for any position that doesn't require a Z-rod hole or bearing, in my case it's used on the upper right (single Z setup).
Support_CR-10_608ZZ_Bearing.stl: With Z-road using the readily available 608ZZ bearing (instead of the one originally shipped with the printer).
I use these modded versions on my Tevo Tornado, the No Z Thread version on the upper right and the 608ZZ Bearing version on the upper left (single Z setup). As bottom parts I use those from Rear Frame support for Tevo Tornado.
Note that, at least on the Tornado, these can't be used as bottom parts, since there are already screws in place holding the frame together.
Support_CR-10_No_Z_Thread.stl: Without Z-rod / bearing. Intended for any position that doesn't require a Z-rod hole or bearing, in my case it's used on the upper right (single Z setup).
Support_CR-10_608ZZ_Bearing.stl: With Z-road using the readily available 608ZZ bearing (instead of the one originally shipped with the printer).
I use these modded versions on my Tevo Tornado, the No Z Thread version on the upper right and the 608ZZ Bearing version on the upper left (single Z setup). As bottom parts I use those from Rear Frame support for Tevo Tornado.
Note that, at least on the Tornado, these can't be used as bottom parts, since there are already screws in place holding the frame together.