Thingiverse
Z-84 Wing - VTX Antenna Bottom Mount (Pagoda) by dr_drone
by Thingiverse
Last crawled date: 4 years, 7 months ago
I designed this for better reception as I found that I frequently lost video signal on the way back.
You will need two of them, and you will need to drill out a 12 mm hole through your fuselage. Hot glue works good, but I recommend epoxy. If you are using hot glue see to it that you keep it at low temperature otherwise, the PLA will deform.
Using a pagoda is recommended along with its spacers for durability. My antenna has a heatshrink over it.
I'm a student so any tip is greatly appreciated! :)
You will need two of them, and you will need to drill out a 12 mm hole through your fuselage. Hot glue works good, but I recommend epoxy. If you are using hot glue see to it that you keep it at low temperature otherwise, the PLA will deform.
Using a pagoda is recommended along with its spacers for durability. My antenna has a heatshrink over it.
I'm a student so any tip is greatly appreciated! :)