YDX-5C Foldable Mini quadcopter by Webbi001

Last crawled date: 3 years, 1 month ago

This is a model I designed a while back, It does not require any fasteners for the main frame assembly. You might need some screws for the controller board, motors and some good old zip ties for wiring, but you can put the frame together under 3 min.
Noted that for the upper and lower plates you might want to print with slightly denser settings for the infill.
It generally fits all small size control boards, at lease that's the idea...
I have 2206 motors on it with 3mm size mounting holes, I assume it fits most 22XX motors.
I use a wifi transceiver module so the video stream through wifi, which means I didn't have enough space for a FPV transmitter, bu I am sure you can zip tie it on the side or top.
I do recommend taking off the casing of the receiver if you are using regular receivers so that it fits inside of the frame and you can zip tie a FPV transmitter on top.
I previously put this model on Shapeways but they over priced everything so there is no point keeping it there.