xyzprinting AIO y axis cable chain by caj

Last crawled date: 3 years ago

this is for the aio only the way that xyz has wired the y axis harness leaves no room for flex as such there is a horrabel bind on the wires breaking them from inside the sheath right at the point that they placed the tie downs if this has happened then after you have re spliced the wires and repaired the harness this fix will allow your fix to stay fixed
to gain length in the wires for a proper flex move the wire harness from the top of the y motor to the bottom
the plug to the x motor will just unplug but the zero sensor is glued into the housing and you can not just disconnect the plug because of the way that they put the thing together you can either cut a square out of the cover to give you room to remove the plug or what i had to do is cut all 3 wires and re splice them after moving the cable down
the chain is like my other chain 1 in 1 out ect ect so no chain locks and no nead to remove plug ends