Thingiverse
Wyzecam Petagon Mount *Updated
by Thingiverse
Last crawled date: 5 years, 3 months ago
Update I increased the width of the 'Walls' pentagon column. I found that the original had enough wiggle room that it too could shift with vibration. v2 should provide a tighter fit.
This is my second Wyzecam mount. The first has it's place, but this one was designed to allow a closer mount to the ceiling. It's a two piece mount. The metal disc from the Wyzecam slides into the 'Face'. The 'Face' and 'Wall' pieces have inter-locking pentagon's allowing them to be fitted together. My first prototype fitted together with a circle and column, but I found with too much vibration (like a spinning washing machine in the next room) the 'Face' had a tendency to drift.
I would recommend printing with a brim to ensure adhesion. I also slowed down the printing of the outer walls to 30mm.
This is my second Wyzecam mount. The first has it's place, but this one was designed to allow a closer mount to the ceiling. It's a two piece mount. The metal disc from the Wyzecam slides into the 'Face'. The 'Face' and 'Wall' pieces have inter-locking pentagon's allowing them to be fitted together. My first prototype fitted together with a circle and column, but I found with too much vibration (like a spinning washing machine in the next room) the 'Face' had a tendency to drift.
I would recommend printing with a brim to ensure adhesion. I also slowed down the printing of the outer walls to 30mm.