CG Trader
WW2 Bomb | 3D
by CG Trader
Last crawled date: 3 years, 9 months ago
This model of an aerial bomb from World War 2 is about 450 mm high and has a diameter of 220 mm.
The printing is not quite simple. Approximately 1 kilogram of filament is needed in original size. Ideally, one takes immediately PLA or PETG in olive green. This saves a spray can of varnish and a lot of work.
I immediately printed the bolt and the locking ring in silver, but painting this is also no effort.
The printing is not quite simple. Approximately 1 kilogram of filament is needed in original size. Ideally, one takes immediately PLA or PETG in olive green. This saves a spray can of varnish and a lot of work.
I immediately printed the bolt and the locking ring in silver, but painting this is also no effort.