Thingiverse
Worx Diy Power Adaptor UPDATED by bensudworth96
by Thingiverse
Last crawled date: 4 years, 6 months ago
I have designed these battery holders/adaptors for use with the 4-pin WORX UK lithium ion 20V Battery, they are compatible with the 1ah, 1.5ah, 2ah, 4ah and 6ah.
I have made the one that fits a male panel mount XT60 connector which works well, the lip on the connector may need to be cut off to allow it to fit into the holder, I'm not sure of the screw size but the socket can be superglued in. I used double ended spade connectors as battery pins. the pins can be bent to touch the XT60 connector and add a small amount of solder being carful not to melt the holder.
The one that has the two holes in the rounded cornered plate is for use with female crimp connectors and a cable tie to secure the wires, this one i have not made yet but the battery will fit.
The one that doesn't have any extra attachments on is simply for fixing to a surface as a storage option, it still has the holes for the double ended spade connectors which don't have to be used.
I have added a tool holder that has not been printed and not tested so feel free to test it out if you have a drill, impact driver, grinder, jigsaw and any other WORX tools that may be wall mountable.
All the adaptors have countersunk holes for fixing to walls or objects.
Any photos or comments would be very helpful.
Double ended spade connectors:https://www.ebay.co.uk/itm/223527499727
XT60 connectors:https://www.ebay.co.uk/itm/184214502895
Update: they have been modified to take the 4 and 6 ah batteries which have an extra alignment pin.
I have made the one that fits a male panel mount XT60 connector which works well, the lip on the connector may need to be cut off to allow it to fit into the holder, I'm not sure of the screw size but the socket can be superglued in. I used double ended spade connectors as battery pins. the pins can be bent to touch the XT60 connector and add a small amount of solder being carful not to melt the holder.
The one that has the two holes in the rounded cornered plate is for use with female crimp connectors and a cable tie to secure the wires, this one i have not made yet but the battery will fit.
The one that doesn't have any extra attachments on is simply for fixing to a surface as a storage option, it still has the holes for the double ended spade connectors which don't have to be used.
I have added a tool holder that has not been printed and not tested so feel free to test it out if you have a drill, impact driver, grinder, jigsaw and any other WORX tools that may be wall mountable.
All the adaptors have countersunk holes for fixing to walls or objects.
Any photos or comments would be very helpful.
Double ended spade connectors:https://www.ebay.co.uk/itm/223527499727
XT60 connectors:https://www.ebay.co.uk/itm/184214502895
Update: they have been modified to take the 4 and 6 ah batteries which have an extra alignment pin.