World of Warcraft Napkin Holder

Last crawled date: 4 years, 2 months ago

Here is a Word of Warcraft napkin holder, inspired by my love for the game.
No multi-extruder is required if your slicer supports pausing prints to change the filament colour. I used Prusa Slicer 2.2.0 and changed colours at the following layer heights:
Base: 1 - 14 (Black), 15 - 18 (Grey), 19 - 20 (Black)
Sides: 1 - 6 (Black), 7 - 12 (Red/Blue), 13 - 18 (Black)
The above only applies to a layer height of 0.2mm, and when printed with the logos facing upwards
Each of the sides slide into the base, but you can use glue to keep it a little more secure.
Enjoy!