Thingiverse
Wireless Access Point Mount for Lulzbot Mini by Noggin011
by Thingiverse
Last crawled date: 4 years, 12 months ago
This is a pair with my raspberry pi mount.
I used this to mount the PC board from a cheap d-link WAP so that the printer creates its own network. I use this with a Raspberry Pi 3 and octoprint.
My Pi mount has a regulator built in to supply 5v for the WAP so its all powered from the printer.
Its in three pieces, the same as the pi mount so that you can match your colours and make it interesting! You will need one of each. It uses the existing holes in the lulzbot mini. I used a tap to thread the holes for m5 bolts, be careful because there is very little clearance between the z carriage and the side of the printer. You also need 4 M3 bolts to attach the lid.
I can find the model number of the WAP this is designed for, I will update when I find it.
I used this to mount the PC board from a cheap d-link WAP so that the printer creates its own network. I use this with a Raspberry Pi 3 and octoprint.
My Pi mount has a regulator built in to supply 5v for the WAP so its all powered from the printer.
Its in three pieces, the same as the pi mount so that you can match your colours and make it interesting! You will need one of each. It uses the existing holes in the lulzbot mini. I used a tap to thread the holes for m5 bolts, be careful because there is very little clearance between the z carriage and the side of the printer. You also need 4 M3 bolts to attach the lid.
I can find the model number of the WAP this is designed for, I will update when I find it.