Thingiverse
Wire Shelf Support (30 Degrees) by denos
by Thingiverse
Last crawled date: 4 years, 1 month ago
Our house had a bunch of 30 degree wire shelves but the original support design was weak and several have broken over time.
This is my attempt at creating something stronger. It's basically an I-Beam that has been rounded to print without supports. The I-Beam also supports both faces to prevent them from fracturing along the center line (the most common failure point).
This is my attempt at creating something stronger. It's basically an I-Beam that has been rounded to print without supports. The I-Beam also supports both faces to prevent them from fracturing along the center line (the most common failure point).