WingNut by BRNT

...part part part by ease thingiverse part part part

...b(curvy thing) on the sticking out part of drawer top part. 9.connect the assembled pieces from part 3 in to the whole on part 4.

...parts grabcad parts of parts

...part grabcad part part

...parts caddy 3dwarehouse parts caddy for small hobby parts #caddy #hobby #part #parts #small #steinie44

...machine design part cg trader machined part machine design part vehicle parts other vehicle part

...ings, part printed only as outlines math part, body part, letter part ...and print the corresponding filament mount thing:1295695

...rendered parts grabcad these parts are rendered parts.

...mechanical parts 4fun cg trader mechanical parts mechanical parts 4 fun 3d model vehicle part vehicle part

...g trader exhaust manifold exhaust manifold car parts engine vehicle part vehicle part car engine car part car parts engine parts

...tube mount by brnt thingiverse part of the armset building system attaches a 5/16" rod to a surface by means of two screws.

...grip knob ( no. 60975k57...http://www.mcmaster.com/#machine-component-knobs/=hv3j95 for ball-in-socket variable angle connections

...to a variable angle ball-in-socket using a 1.25" comfort grip knob http://www.mcmaster.com/#machine-component-knobs/=hv3j95

...hreaded rod perpendicularly to a standard 1" broom handle in eight directions, each 45â° apart. relates to the variadapter.

...n the gears to simultaneously turn clockwise and counter-clockwise, tightening or untightening the connection with a single turn.

...nt thingiverse part of the arm set building system. this part connects two standard 5/16"-18 threaded rods perpendicularly.

...oint by brnt thingiverse part of the arm set building system this part connects two 5/16"-18 threaded rods in a 45â° angle.

.../16" threaded rod to the edge of a board via 3 screws. it can also be used to join two boards at an edge and used as a hinge

...ystem this part can connect up to three 5/16"-18 threaded rods perpendicularly in a "xyz" or corner configuration.

...wingnut wrench by lisatoddsean2006 thingiverse wingnut wrench

...wingnut by m1232 thingiverse

...parametric wingnut by dddddyck thingiverse basic parametric clip-on wingnut for hex bolts and nuts.

...ter. although it's designed for my specific printer, scaling it up or down should make it usable with various sized wingnuts.

...small as can be diameter vise. only found too short models or ones that don't hold wingnut in place (=goes through the model)

...t replacement. useful replacement for idlre tensioner in x and y axis and for heatbed leveling without the need of screwdriver...

...se these are some wingnut adapters for 5/16 (quarter inch thick) nuts. designed by pratt industrial design student brent collins

...wingnut fitting for standard hex bolt by jondallimore thingiverse wingnut fitting for standard hex bolt.

...ent you use sometimes the fit is too tight. in those cases you can simply change a little bit the printing scale in your printer.