Thingiverse
Wii Gamecube Controller Port Cover by Mburr
by Thingiverse
Last crawled date: 4 years, 7 months ago
I decided to post this pre-print. As i am posting this, I am printing it.
This is a top cover for the wii. I had mine, but the knobs have broken off. I designed the knobs from the gamecube memory cover and measured out the rest.
If someone does have a better model, please point me in that direction, i couldnt find one anywhere i looked... so it would be much appreciated. But until then, i will continue to model this.
Edit #1: I saw that the left most knob was slightly above the actual model. Fixed.
Also i printed it, i have the mesurments right, but the print failed. I had 0% infill on for some reason... printing again...
Edit #2: Printed sucsessfully. The knobs are really fragile, and it was hard to get the support material off. I had some major oozing issues too. Also, i was basing it off of the gc memory cover, and the knobs are orented diffrently, fixed the oreintation. Also the knobs were 2 mm too big. changed that. Hope this turns out perfect, printing again!
Edit #3: Printed. It fits in my wii, but it is a little off center. the knobs are a tiny bit too big, but its unnoticable unless you look at it closly, and even with that you can sand it down, After i sanded it down a little bit it looks much better on my wii! more flush corners and its smoother. Ill add the memory cover sometime in the futer
This is a top cover for the wii. I had mine, but the knobs have broken off. I designed the knobs from the gamecube memory cover and measured out the rest.
If someone does have a better model, please point me in that direction, i couldnt find one anywhere i looked... so it would be much appreciated. But until then, i will continue to model this.
Edit #1: I saw that the left most knob was slightly above the actual model. Fixed.
Also i printed it, i have the mesurments right, but the print failed. I had 0% infill on for some reason... printing again...
Edit #2: Printed sucsessfully. The knobs are really fragile, and it was hard to get the support material off. I had some major oozing issues too. Also, i was basing it off of the gc memory cover, and the knobs are orented diffrently, fixed the oreintation. Also the knobs were 2 mm too big. changed that. Hope this turns out perfect, printing again!
Edit #3: Printed. It fits in my wii, but it is a little off center. the knobs are a tiny bit too big, but its unnoticable unless you look at it closly, and even with that you can sand it down, After i sanded it down a little bit it looks much better on my wii! more flush corners and its smoother. Ill add the memory cover sometime in the futer