Thingiverse
Wheel Flipper/Flicker by paranoia2mb
by Thingiverse
Last crawled date: 4 years, 3 months ago
4-Piece Wheel Flipper/Flicker and Base that can be used to mount onto a bolt.
The Top, Bottom, and Base should all be printed with PLA.The Bottom piece of the flipper should be printed with supports (revision 2.0 perhaps I can fix the design so no supports are needed)
The Middle Flipper should be printed with a soft material such as TPE or TPU (pictured, it is printed with TPE), so when it hits the steel pegs on the wheel you get that satisfying noise like on the TV show.Follow the settings for your specific printer when printing these materials
Additional work is needed to make this fully functional, but everything is available at your local home improvement store:
3 inch 1/4 bolts
1/4 T Nut to hold the bolt
1/4 Washers
Metal T Shape connector, bent to act as a support as well as to keep the base centered and straight
Rubber band to support the "flicking" motion
Assorted screws
The Top, Bottom, and Base should all be printed with PLA.The Bottom piece of the flipper should be printed with supports (revision 2.0 perhaps I can fix the design so no supports are needed)
The Middle Flipper should be printed with a soft material such as TPE or TPU (pictured, it is printed with TPE), so when it hits the steel pegs on the wheel you get that satisfying noise like on the TV show.Follow the settings for your specific printer when printing these materials
Additional work is needed to make this fully functional, but everything is available at your local home improvement store:
3 inch 1/4 bolts
1/4 T Nut to hold the bolt
1/4 Washers
Metal T Shape connector, bent to act as a support as well as to keep the base centered and straight
Rubber band to support the "flicking" motion
Assorted screws