Thingiverse
Werkzeughaltersystem, Meterstab, Toolbox for folding rule by cheffeundwackl
by Thingiverse
Last crawled date: 4 years, 7 months ago
Servus,
This here is the holder for a folding rule.
I have the drawing for the trigger with published. Maybe fit a different tool as well.
For load / unload the tool must be slightly tilted. So you need space for load / unload (look at the picture).
I got me here made a complete system for tool holder. I do not like when the tool is loose in the case.
So now I have a separate holder for each tool creates. This holder can be screwed onto a plywood board now. (Spax 3 mm). Holes for the screws are integrated.
I then installed these plywood panels vertically with U-profiles in a Tanos Systainer http://www.systainer.de. On an area of ÃÂ300 mm x 400 mm I get so below about 60 tools (screwdriver, wrench set, pliers, electric tester ...).
I have the created in Catia V5. If someone original files needed, please contact me
This here is the holder for a folding rule.
I have the drawing for the trigger with published. Maybe fit a different tool as well.
For load / unload the tool must be slightly tilted. So you need space for load / unload (look at the picture).
I got me here made a complete system for tool holder. I do not like when the tool is loose in the case.
So now I have a separate holder for each tool creates. This holder can be screwed onto a plywood board now. (Spax 3 mm). Holes for the screws are integrated.
I then installed these plywood panels vertically with U-profiles in a Tanos Systainer http://www.systainer.de. On an area of ÃÂ300 mm x 400 mm I get so below about 60 tools (screwdriver, wrench set, pliers, electric tester ...).
I have the created in Catia V5. If someone original files needed, please contact me