Thingiverse
Wearable Royal Crown by Jimbotron
by Thingiverse
Last crawled date: 4 years, 8 months ago
I made this for a co-worker friend who wanted a wearable crown. It came out pretty nice, so I may as well share.
Print Instructions:
Slice
Print :)
If you want different color balls (as in my picture) then change the filament color after about 80-81 percent of the print.
** For kids sizing - use about 84 to 88% scale to shrink it down a bit. Also, if your printer is limited to 200x200 use 93 or less scaling to fit.
Print Instructions:
Slice
Print :)
If you want different color balls (as in my picture) then change the filament color after about 80-81 percent of the print.
** For kids sizing - use about 84 to 88% scale to shrink it down a bit. Also, if your printer is limited to 200x200 use 93 or less scaling to fit.