Thingiverse
Water drain pipe cap, diameter 192mm by deltapenguin
by Thingiverse
Last crawled date: 4 years, 1 month ago
Cap for water drain pipe whose diameter is 192 mm.
I used two types of filament. The yellow one is eSun FLEX. Its printing time was 11 hours 30 minutes with 0.4 mm nozzle.
The brown one is FiloMAN PLA. Its printing time was 3 hours 15 min with 0.8 mm nozzle, E3D Volcano.
The green plates made out of rubber were glued by general purpose silicon.
I used two types of filament. The yellow one is eSun FLEX. Its printing time was 11 hours 30 minutes with 0.4 mm nozzle.
The brown one is FiloMAN PLA. Its printing time was 3 hours 15 min with 0.8 mm nozzle, E3D Volcano.
The green plates made out of rubber were glued by general purpose silicon.