Thingiverse
Wanhao i3 Z-endstop large range of change by JonBAL
by Thingiverse
Last crawled date: 4 years, 7 months ago
It does not need additional screws.
The two parts are joined pieces of filament 1.75mm. You can use a bit of glue, but this is usually not required.
You can change the height on both sides. Upwards such as glass on the bed. Or down, if you are using a different extruder.
The two parts are joined pieces of filament 1.75mm. You can use a bit of glue, but this is usually not required.
You can change the height on both sides. Upwards such as glass on the bed. Or down, if you are using a different extruder.