Thingiverse
Wanhao I3 v2 / Maker Select mounting bracket for FYSETC 67*32mm mosfet by ej0rge
by Thingiverse
Last crawled date: 4 years, 6 months ago
Mounting bracket to add the more compact style 66.6mm * 32mm fysetc mosfet next to the melzi board in a wanhao duplicator i3 v2.1 or similar.
The larger bosses should fit around the bosses for the melzi at the rear of the control box - the melzi board will clamp them down firmly, and the smaller bosses should allow easy self-tapping for M3 screws to attach the fet board. You may need a bit of double-sided tape or a dot of glue at the far end of the bracket.
This mosfet:
https://www.ebay.com/itm/3D-Printer-Heating-Controller-30A-Heatbed-MKS-MOS-MOSFET-Module-Expansion-TE828/372426348189
https://www.aliexpress.com/item/New-Hot-3D-Printer-Accessories-Heating-Controller-30A-Heatbed-MKS-MOS-MOSFET-Module-Expansion-8/32888946495.html
Inspired by but not remixed from similar mounts.
The larger bosses should fit around the bosses for the melzi at the rear of the control box - the melzi board will clamp them down firmly, and the smaller bosses should allow easy self-tapping for M3 screws to attach the fet board. You may need a bit of double-sided tape or a dot of glue at the far end of the bracket.
This mosfet:
https://www.ebay.com/itm/3D-Printer-Heating-Controller-30A-Heatbed-MKS-MOS-MOSFET-Module-Expansion-TE828/372426348189
https://www.aliexpress.com/item/New-Hot-3D-Printer-Accessories-Heating-Controller-30A-Heatbed-MKS-MOS-MOSFET-Module-Expansion-8/32888946495.html
Inspired by but not remixed from similar mounts.