Thingiverse
Wanhao Duplicator i3 Z align by mvr
by Thingiverse
Last crawled date: 4 years, 7 months ago
Tool for Z-alignment of the Wanhao Duplicator i3.
You need two of these.
Move the printhead up a little.
Then snap the aligners onto the lower bar, one on each side.
With the steppers turned off, manually turn the left and rigth steppers until the alignment bars touch the chassis.
You need two of these.
Move the printhead up a little.
Then snap the aligners onto the lower bar, one on each side.
With the steppers turned off, manually turn the left and rigth steppers until the alignment bars touch the chassis.