Wanhao D12 BLTouch mount by billythedev 3d model
3dmdb logo
Thingiverse
Wanhao D12 BLTouch mount by billythedev

Wanhao D12 BLTouch mount by billythedev

by Thingiverse
Last crawled date: 4 years, 9 months ago
This mount was designed to install a BLTouch on a Wanhao Duplicator 12. It is based on the Bl Touch mount for wanhao I3 plus made by Gubbi24 licensed under CC BY 4.0 (https://www.thingiverse.com/thing:3680098).
You can find BLTouch installation instructions (in French) here : https://www.youtube.com/watch?v=N_Xe__Rds9I
For the original Wanhao D12 (grey version), you will need to update the robin_nano35_cfg.txt file by setting INVERT_Z_DIR 1 to INVERT_Z_DIR 0 before installing the firmware!
Please be careful to always be ready to stop the printer (to avoid damaging your bed or printer head).
I connected my BLTouch to the Z- pins (instead of the Z+ on the official Wanhao video).
I used 2 M3*7mm, 2 M3*4mm screws and 2 M3 nuts to mount the BLTouch and the support.
I also removed some material from the BLTouch that was touching the 4mm screws.
You first need to attach the support to the printer head using the 2 M3*4mm.
The M3*7mm and M3 nuts helps attach the BLTouch to the support.

Tags