Thingiverse
Wall Mount Raspberry Pi 2,3 Sleeve Case by hackerseraph
by Thingiverse
Last crawled date: 4 years, 1 month ago
Added 2 mounts with screw hole. This will need to be printed upright, with supports.
Was a little bit of a tight fit, so if your HDMI snags because sometimes they get soldered a bit offset, just hit the inside by the headphone jack with a small file, and it should slide with ease.
Picture is a Pi3 in the case, and a Pi2 in the background.
This is remixed from http://www.thingiverse.com/thing:604915
Was a little bit of a tight fit, so if your HDMI snags because sometimes they get soldered a bit offset, just hit the inside by the headphone jack with a small file, and it should slide with ease.
Picture is a Pi3 in the case, and a Pi2 in the background.
This is remixed from http://www.thingiverse.com/thing:604915