Thingiverse
Walking Gear Robot (V-switch)
by Thingiverse
Last crawled date: 5 years, 7 months ago
Once again many thanks to otvinta3d for this great robot mechanism!
Actually everything works very well!
I'm a little bothered ;-) by the fact that you have to fiddle with the cable ends to get the device going. Therefore I made some changes to wg_motorholder.stl. The most important change is the mounting of a switch box. As a result, some changes had to be made to the cable routing and/or cable passages.
Here you can see the result in work: https://youtu.be/ObhKLGLw-44
These are the stl files with the changes:
wg_motorholder_V-switch.stl
wg_switchcover_V-switch.stl
Both parts can be printed without support.
All other required stl files are unchanged:https://www.thingiverse.com/thing:2036149
I used the following component:
AC 125 V 6A ON-ON 3 Pins 2 Position Mini Toggle Switch
Actually everything works very well!
I'm a little bothered ;-) by the fact that you have to fiddle with the cable ends to get the device going. Therefore I made some changes to wg_motorholder.stl. The most important change is the mounting of a switch box. As a result, some changes had to be made to the cable routing and/or cable passages.
Here you can see the result in work: https://youtu.be/ObhKLGLw-44
These are the stl files with the changes:
wg_motorholder_V-switch.stl
wg_switchcover_V-switch.stl
Both parts can be printed without support.
All other required stl files are unchanged:https://www.thingiverse.com/thing:2036149
I used the following component:
AC 125 V 6A ON-ON 3 Pins 2 Position Mini Toggle Switch