VS Module for Flight Simulators by AndersBay

Last crawled date: 3 years, 1 month ago

This VS knop is the first module for my low cost modular flight simulator Panel. The idea is that the user is able to print only the modules which is needed and then combine them with an Arduino mega og micro. The software I use and recommend is called Mobiflight check them out Here.
All fastners used are M3x8 countersunk screw, since I had like 100 of them from a previous project. Remember to tap the holes before screwing.
The momentary push buttons used are the KD2-22 with LED. I used these because of the LED inside it and this would not mess up the simulator if a button was pushed in the game. These can be found Here.
How to connect these to the Arduino is pictured above.
For the Rotary encoder I used KY-040, which can be bought Here.
There is small hole on each side for wires to run to the arduino, these a maybe too small for your wire so maybe consider making them wider.
I hope you enjoy.