Thingiverse
Vortex 285 Battery and antenna protector by jelte1234
by Thingiverse
Last crawled date: 5 years, 4 months ago
This thing is supposed to protect the battery of your Vortex 285 drone from your props, if the arms fold in!
The extra bumps on the side help to absorb lots of force.
It also protects the SMA connector, and the antenna in a crash.
I found it extremely worth printing; see the picture of the white one (previous revision) to see why! There's a 2-3mm deep gouge in the side! My battery would not have liked that..
Save your battery, print this today!
Fits up to 33mm thick batteries, higher version available upon request.
The one labeled "Printedplate" is for people who have printed a bottom/camera protector, which might be just a bit thicker. The normal one leaves 25mm room, this version gives 25.8mm. If you're unsure, use calipers!
The extra bumps on the side help to absorb lots of force.
It also protects the SMA connector, and the antenna in a crash.
I found it extremely worth printing; see the picture of the white one (previous revision) to see why! There's a 2-3mm deep gouge in the side! My battery would not have liked that..
Save your battery, print this today!
Fits up to 33mm thick batteries, higher version available upon request.
The one labeled "Printedplate" is for people who have printed a bottom/camera protector, which might be just a bit thicker. The normal one leaves 25mm room, this version gives 25.8mm. If you're unsure, use calipers!