Thingiverse
Volcano Part Cooling Duct for Prusa i3 MK2 by Megabound
by Thingiverse
Last crawled date: 4 years, 4 months ago
30/10/2017: Last one I swear. This duct is perfect if you don't want to run the downlight. I had some issues with the front of the duct catching on prints, but this newest version eliminates that issue with a more direct profile.
08/09/2017: Ch-ch-ch-changes! A couple modifications for a more streamlined profile. The excessive cutout from the centre is to support downlighting. A 60mm 12V halo light fits around the volcanos block nicely and is suppoted by the fan duct.
Print me before you install your volcano setup, I used ABS and supports are a must.
A simple part fan for running a volcano on your MK2. This is the final version, the duct works wonderfully and the heater block is copping no where near as much fan any more. You may need to alter it to fit your particular set-up perfectly but I'm now happy with the outcome. Can't recommend a part fan enough for PET at this scale.
Get my Fusion 360 files here: http://a360.co/2s9sgTP
08/09/2017: Ch-ch-ch-changes! A couple modifications for a more streamlined profile. The excessive cutout from the centre is to support downlighting. A 60mm 12V halo light fits around the volcanos block nicely and is suppoted by the fan duct.
Print me before you install your volcano setup, I used ABS and supports are a must.
A simple part fan for running a volcano on your MK2. This is the final version, the duct works wonderfully and the heater block is copping no where near as much fan any more. You may need to alter it to fit your particular set-up perfectly but I'm now happy with the outcome. Can't recommend a part fan enough for PET at this scale.
Get my Fusion 360 files here: http://a360.co/2s9sgTP