Thingiverse
Vase #003 (read instructions) by Snakedad
by Thingiverse
Last crawled date: 4 years, 7 months ago
When importing into your slicer of choice, it will probably complain about the model not being manifold. It's just because the top and bottom isn't closed. Won't cause any problems when printing.
Made the model taller after exporting from fusion, which is why it doesn't look exactly the same.
Instructions(cura):
Quality:
Layer hight: 0.2mm
Line width: 0.6mm
Shell:
Bottom layers: 4
Special modes:
Spiralize outer contours: [X]
Printing with a 0.4mm nozzle, you might want to lower printing speed and raise temps a smidge.
Slice and print!
Made the model taller after exporting from fusion, which is why it doesn't look exactly the same.
Instructions(cura):
Quality:
Layer hight: 0.2mm
Line width: 0.6mm
Shell:
Bottom layers: 4
Special modes:
Spiralize outer contours: [X]
Printing with a 0.4mm nozzle, you might want to lower printing speed and raise temps a smidge.
Slice and print!