V8 Block for Steiner3D i4 engine by aRych

Last crawled date: 4 years, 11 months ago

I was able to adapt the i4 block as a v8. It is unlike actual v8 engines in the fact that it can use the same i4 crank but with half-width conrods because the banks are mirrored rather than offset. The i4 heads and many other components are preserved as well.
I will have a full write-up when finalized/released.
v14 issues:
scale is off by 10x (this will be fixed on release)
have not figured out timing belt/gear paths
unlike DeSteiner's, this block will be somewhat hard to print efficiently