Thingiverse
USB Cable Holder Fist for Geeetech A10 Extruded Frame by Jpdenzer
by Thingiverse
Last crawled date: 4 years, 6 months ago
The original design was great. The only problem is that it fits Ender 3. So I flipped the hand to fit my Geeetech A10.
https://www.thingiverse.com/thing:4441076 presented a thumb screw to replace the wing nut on the front-left corner of the BIBO bed. It is too wide for the other two positions.
I have created a smaller version to fit the right-front corner and the back-center.
A M3-.50 nut is required.
https://www.thingiverse.com/thing:4441076 presented a thumb screw to replace the wing nut on the front-left corner of the BIBO bed. It is too wide for the other two positions.
I have created a smaller version to fit the right-front corner and the back-center.
A M3-.50 nut is required.