Thingiverse
UP3D Plus 2 Plexi Enclosure by JamesNewton
by Thingiverse
Last crawled date: 4 years, 5 months ago
Manually edited the SVG files from fumalcon to
Break each part out into a separate file.
change units to mm and
changed line width to 1mm so it is visible (Epilog users will need to go back to 0.001, I guess?)
scale to correct size. (I hope)
The scale is the scariest part as it was based on measuring my actual printer and then measuring the SVG file and then scaling everything by that factor. It ended up being scale(1.339) as a best guess, and I DID cut one side panel in cardboard which DID fit perfectly.
However... at about that point I realized that my printer has the nozzle auto adjust connector which extends the back out quite a bit. So now there are "...Deep" and "...Shallow" versions of the left and right side, TopBack, and BackFloor parts.
As time allows, I'll cut a set from cardboard and verify they work, then do them again in plex.
Break each part out into a separate file.
change units to mm and
changed line width to 1mm so it is visible (Epilog users will need to go back to 0.001, I guess?)
scale to correct size. (I hope)
The scale is the scariest part as it was based on measuring my actual printer and then measuring the SVG file and then scaling everything by that factor. It ended up being scale(1.339) as a best guess, and I DID cut one side panel in cardboard which DID fit perfectly.
However... at about that point I realized that my printer has the nozzle auto adjust connector which extends the back out quite a bit. So now there are "...Deep" and "...Shallow" versions of the left and right side, TopBack, and BackFloor parts.
As time allows, I'll cut a set from cardboard and verify they work, then do them again in plex.