Thingiverse
Unwinder / Spool Holder 6 Places (for Zivipf Spools) by mc0676
by Thingiverse
Last crawled date: 4 years, 7 months ago
Attention: this is a WIP project.
With this holder u can use 6 wire spool (Zivipf spool: about 55x10 mm) during the rebuilt of your atomizer.
In the front panel u can attach some label to describe the specified wire.
U need too:
4 5x1 magnets: for the front panel;
12 3x2 magnets.for the wire lock but u can fix with some glue too.
U can print the body WITHOUT support.
About the wire_lock there are two solution:
with spool stopper;
without spool stopper.
For bigger wire (kh & nicr > 0,40) i suggest use the stopper version.
For other one u can use the normal version.
If u do not like the stopper version u can use to friction the spool some adhesive sponge (like in the shots).
With this holder u can use 6 wire spool (Zivipf spool: about 55x10 mm) during the rebuilt of your atomizer.
In the front panel u can attach some label to describe the specified wire.
U need too:
4 5x1 magnets: for the front panel;
12 3x2 magnets.for the wire lock but u can fix with some glue too.
U can print the body WITHOUT support.
About the wire_lock there are two solution:
with spool stopper;
without spool stopper.
For bigger wire (kh & nicr > 0,40) i suggest use the stopper version.
For other one u can use the normal version.
If u do not like the stopper version u can use to friction the spool some adhesive sponge (like in the shots).