Thingiverse
Universal 10x10 cable chain brackets by rAthus
by Thingiverse
Last crawled date: 4 years, 8 months ago
I wasn't satisfied with cable chains mounts I found for my AM8 frame Y axis so I made these "universal" ones with bottom part that will fit just right on a 2040 profile, a 2020, or pretty much anything you can screw on, and top part that will fit any H carriage under the bed.
You should be able to adjust the brackets so they work with any setup thank to long holes for the bolts, it's a simple yet efficient design.
They are meant to hold any standard 10x10mm cable chains like this one on AliExpress for example (you might find it cheaper if you look by yourself, depending on your location).
I made 2 versions depending if you want to put the chain on the left side or the right side of your printer (when you're facing it).
I'm using them with an Anycubic Ultrabase heatbed that has free wires soldered under the bed, my design won't allow you to fit the sock bed's white plug in it, you'll have to either mount the bracket away from the plug and run the wires into it, or buy an Ultrabed, which is what you should do, as it's an awesome product, I'm not getting anything to say that, it's just what it is, I've tested bare bed, blue tape, glue, bare glass, hair spray, and in the end Ultrabase is just the perfect surface, prints stick so well you could lift the whole printer if you pull them when still hot, and yet they come of with a single finger after you let the bed cool down entirely.
Well maybe I've lost track of what I was saying in the first place! :D
Do not hesitate to give me your feedback on my design I'll improve it if needed, and post your pictures in the "Made" section! :)
You should be able to adjust the brackets so they work with any setup thank to long holes for the bolts, it's a simple yet efficient design.
They are meant to hold any standard 10x10mm cable chains like this one on AliExpress for example (you might find it cheaper if you look by yourself, depending on your location).
I made 2 versions depending if you want to put the chain on the left side or the right side of your printer (when you're facing it).
I'm using them with an Anycubic Ultrabase heatbed that has free wires soldered under the bed, my design won't allow you to fit the sock bed's white plug in it, you'll have to either mount the bracket away from the plug and run the wires into it, or buy an Ultrabed, which is what you should do, as it's an awesome product, I'm not getting anything to say that, it's just what it is, I've tested bare bed, blue tape, glue, bare glass, hair spray, and in the end Ultrabase is just the perfect surface, prints stick so well you could lift the whole printer if you pull them when still hot, and yet they come of with a single finger after you let the bed cool down entirely.
Well maybe I've lost track of what I was saying in the first place! :D
Do not hesitate to give me your feedback on my design I'll improve it if needed, and post your pictures in the "Made" section! :)