Thingiverse
UniFi Home Network - Mini Rack Half Size by Maj
by Thingiverse
Last crawled date: 4 years, 11 months ago
I liked the original design of this mini rack, but I didn't like the way it covered about half of the air holes on the side of the US8s and USG, so I reduced its height/depth to 50%. So now it has better airflow, is quicker to print and is still stable.
If you have any full size blocks already printed, they will still fit on top (but not bottom) of the half size blocks but they stick out a bit.
I've also made an 8 slot cable guide and a few joiners to hold the columns in place, relative to each other. The joiners are Front to Back, Left to Right and Full (4 post) joiner. The joiners can go anywhere in the stack.
I used rafts for the wide/long items (like joiners and cable guide) and brim for the rest.
If you have any full size blocks already printed, they will still fit on top (but not bottom) of the half size blocks but they stick out a bit.
I've also made an 8 slot cable guide and a few joiners to hold the columns in place, relative to each other. The joiners are Front to Back, Left to Right and Full (4 post) joiner. The joiners can go anywhere in the stack.
I used rafts for the wide/long items (like joiners and cable guide) and brim for the rest.