Uneekor QED DIY Club Sticker Aids by stevnkrn

Last crawled date: 3 years, 5 months ago

These two tools are intending for those wanting to make their own Uneekor QED reflective club stickers. The stencil (and a very sharp tip razor knife) allow users to easily cut their own accurately sized club stickers from a roll or sheet of reflective tape. The application aid makes installation of the club sticker on irons easier. Just follow the steps outlined on the attached photo.
Use a sharp, fine tip blade to cut the stickers. I found it easier if you just cut through the top, reflective layer and not through the liner. Clean the top of the club with rubbing alcohol to improve sticker adhesion. Depending on 3D printer accuracy it may be necessary to make small scale adjustments to the stencil to get the stickers to come out the right dimensions. For marking sticker location on clubface use a pencil or fine time sharpie - something that can easily be seen yet easily removed after each sticker is applied.