Thingiverse
Underhung Business Card Holder by CoreElectronics
by Thingiverse
Last crawled date: 4 years, 11 months ago
Ever wanted a sturdy business card holder that can stand the test of time and also be underslung? Well we did and here it is in case you do too.
Very strong design when printed with PLA, soft ergonomic edges, big face at the front bottom for a barcode and fully customisable. Load up 400 business cards and thanks to the downward slant of the design they will not fall out.
Print as seen above and it will require only minimal supports for the screwing in locations. Either inlay a bolt and glue it in place or screw directly into the design from above to affix it.
You want the design to be even more strong? Then increase the infill and the wall thickness.
Very strong design when printed with PLA, soft ergonomic edges, big face at the front bottom for a barcode and fully customisable. Load up 400 business cards and thanks to the downward slant of the design they will not fall out.
Print as seen above and it will require only minimal supports for the screwing in locations. Either inlay a bolt and glue it in place or screw directly into the design from above to affix it.
You want the design to be even more strong? Then increase the infill and the wall thickness.