Thingiverse
Two Up Upper Z Rod Guide mounts (For 8mm Linear Rods) by RickSanchez137
by Thingiverse
Last crawled date: 4 years, 5 months ago
These were an attempt to fix the gantry sag that plagues the Two Up. I was hoping that it would help keep the Z rods square to the Y axis.
While it seemed to help, the print immediately after installation was really good, the same print done after had the Z wobble back.
Just thought maybe someone could play with it or see if it helps them as it will strengthen the whole setup.
It will cause you to loose about 12mm of Z travel
While it seemed to help, the print immediately after installation was really good, the same print done after had the Z wobble back.
Just thought maybe someone could play with it or see if it helps them as it will strengthen the whole setup.
It will cause you to loose about 12mm of Z travel