Thingiverse
Two Axis Desk Clamp by gelberdaniel19
by Thingiverse
Last crawled date: 4 years, 8 months ago
This is a small clamp that can be attached to a table or desk. It is designed to rotate 180 degrees in front of itself and it can be raised and lowered.
Constraints:
Desk must be less than 60 mm thick
Clamped object must be shorter than 60 mm
Several kilos supported at 15% infill
Notes:
The rotate shaft is printed at 9.85 mm. If you find the clamp drooping too much, you can print a new one slightly thicker. Alternatively, if the arm won't rotate well, you can print one slightly smaller.
If too much weight is added, the only part that will break, the rotate peg, is the smallest part. It can easily be reprinted in 3 minutes!
If you want to design your own caps for the clamp rather than the round ones provided, the holes they are inserted into are 7 mm in diameter and 5.2 mm deep.
Constraints:
Desk must be less than 60 mm thick
Clamped object must be shorter than 60 mm
Several kilos supported at 15% infill
Notes:
The rotate shaft is printed at 9.85 mm. If you find the clamp drooping too much, you can print a new one slightly thicker. Alternatively, if the arm won't rotate well, you can print one slightly smaller.
If too much weight is added, the only part that will break, the rotate peg, is the smallest part. It can easily be reprinted in 3 minutes!
If you want to design your own caps for the clamp rather than the round ones provided, the holes they are inserted into are 7 mm in diameter and 5.2 mm deep.