Tweaker5 XT60 + SMA Antenna Mount + Piezo Buzzer Mount for KK2 KK2.1 by jbleazie

Last crawled date: 3 years ago

Tweaker5 220mm : XT60 + SMA Antenna Mount + Piezo Buzzer Mount for KK2 KK2.1
by jbleazie & Figles, published July 29, 2016
*Second and third versions added.
Inspired by Arakon & nickroosen concept.The Original design was for the Tweaker 180mm frame.
Mounts to the rear standoffs of an Andy Shen "Tweaker5" 220mm frame.http://shendrones.myshopify.com/collections/frames/products/tweaker-5-pre-order
I really liked this concept, but it was only available for the smaller frame. My friend aka "Figles" helped modify the original design by Arakon & nickroosen. I kept breaking the SMA connector vertically mounted to the frame, so we added an angled antenna mount to hopefully minimize the strain on the connector. You can use an SMA Male to SMA Female RG316 Extension Cable.https://www.fpvheadquarters.com/fpv/accessories/sma-accessories.html
Piezo Buzzer mount Dimensions (Buzzer): 9 x 11.8mm
There is also space on the rectangular rear plate allowing you to mount a short LED strip.
Tweaker 180 XT60 + Antenna Mount + Buzzer Mount
by nickroosen, published May 18, 2016
Remix of Arakon's mount. Added a holder for a 12mm buzzer. I wanted to stop hot-gluing mine to the side of the mount. Used TPU for added flexibility, as I've now broken two after impacts. The TPU also allows for some compression on the pigtail so my antenna is no longer wobbly.
Tweaker 180 XT60 + Antenna mount
by Arakon, published Nov 29, 2015
Update:
V2 added. Strengthened the antenna area some and closed it off entirely (no open side anymore).
Mounts to the rear of the Tweaker.
All components should fit easily, for the XT60, apply a drop of CA glue on all four sides before pushing it in.
Meant for use with an angled antenna mount such as http://www.surveilzone.com/5cm-sma-plug-to-right-angle-sma-jack-cable-pa1216
VTX then mounts underneath the top plate of the tweaker.
Rectangular rear plate allows you to stick a short LED strip to it.