Thingiverse
Tulip, fixed for FDM by ryaske
by Thingiverse
Last crawled date: 4 years, 5 months ago
Enjoy these FDM 3d-printable versions of 3dtasari's tulip !!
I liked the original design by 3dtasari, but his OBJ model was not 3d printable, it was way too thin and had a hole running up the center stem. I extruded it to 0.4mm, cut out the inside, sealed off the ends, thickened the stem, and made it a nice 3d printable STL file.
There are two more versions included: Both have the tulip sized up 10%, One adds a mound of "dirt" (makes a good desktop base/raft), and one adding the words I LOVE YOU extruded up from the mound. All prints look great especially with a color change or two.
This was a challenge to make 3d-printable and I am proud of the results. I learned a lot! Print one for your sweetheart
I liked the original design by 3dtasari, but his OBJ model was not 3d printable, it was way too thin and had a hole running up the center stem. I extruded it to 0.4mm, cut out the inside, sealed off the ends, thickened the stem, and made it a nice 3d printable STL file.
There are two more versions included: Both have the tulip sized up 10%, One adds a mound of "dirt" (makes a good desktop base/raft), and one adding the words I LOVE YOU extruded up from the mound. All prints look great especially with a color change or two.
This was a challenge to make 3d-printable and I am proud of the results. I learned a lot! Print one for your sweetheart