Tube Protector by Wildisen486

...towel holder tube protector by espinozar thingiverse tube protector for bathroom towel holder made with pla

...attaches to the steering tube, and you have cables runnin on top of the tube. printing: no supports needed. i printed using petg.

...k40 laser 50w 800mm tube protector. thingiverse made for k40 laser 50w 800mm tube protection.

...les protector easy tpu print by bobberen thingiverse dji fpv goggles lens protector remix for easy print in tpu with bowden tube

...ithout glue the protectors can be pulled out and antenna folded down. the first picture is a prototype without protector tubes.

... akira2k1 thingiverse print using tpu material so antennas can flex and not snap. also use 3mm tube for the tx protector tubes.

...pvc cap nerf reactor spring or spring from a similar ball blaster designed to hold 30+ discs at a...

...on tubing e.g. on a tarot fy-650 / fy-680. just push it in the tubing, if needed add a drop of ca-glue or some double sided tape.

...daichiasuka thingiverse protects the ptfe bowden tube from catching or being cut/scarred by the dibond on the top of the gantry.

... shark fin with sma mount. antenna tubes (long part holds forever tubes, short part goes on the standoff), and wire protectors.

...corner protector thingiverse corner protector

...athletic protector thingiverse athletic protector ;-)

...protector culata thingiverse protector culata motor

...protector de enchufe/ power plug protector by mrozas thingiverse protector para enchuge 220v

...cogmind - protector by sharkprints thingiverse protector

...t16 protector thingiverse i quickly made a gimbal protector that extend to all the switches. printed in tpu.

...ngiverse taranis stick protector taranis stick protector taranis stick protector taranis stick protector taranis stick protector

...ms50 protector by squowse thingiverse ms50 protector

...drone motor protector thingiverse motor protector

...coronavirus protector by oscar3dr thingiverse coronavirus protector

...tubes by thingiverse tube time

...edrio two tubes (tubes) by sidejoebob thingiverse tube for the edrio two tubes helmet

...tube racks thingiverse tube racks for 15ml & 50ml falcon tubes and 20mm round-bottom tubes

...rinted with pla. no support required. suitable for tubes up to 50mm update 03.07.2018 better version uploadet. tube squeezer2.stl

...tube by williandb thingiverse tube

...tube by shvanmajd thingiverse tube

...tube by vovkachuk thingiverse tube

...tube by baramon thingiverse tube

...f a tube leg to assist in sliding across the floor. this was designed for 0.85" od tube but can be scaled for similar sizes.

... brake lines for example). all you need is 8x 608 ball bearing, 8x m8 screw and 8x m8 nut. print list: 2x body 8x roller 1x shims