TS100 + T12 Dual/Quad Soldering Station by sn4k3

Last crawled date: 3 years, 1 month ago

If you are like me that like multiple tools to work or try, nothing better than save space, organize and keep things easy and lightweight.
Features:
Dual output (TS100 + T12 STM32 2.1S OLED / TS100 + T12 STC)
Quad output (4xTS100)
Seven output (7xTS100)
Seven output, cut as you go (NxTS100)
Support two power supply models (6A or 9A)
Independent Switchs for every output including mains
Voltage and current metter for a pleasant view and LiPo voltage control
DC jack for external power supply, eg: LiPo
Bottom vent holes + rubber pad slot
Can change front and back plates easy to convert into other station without reprint main body
Stackable!
BOM:
1 x AC/DC 24V power supplyhttps://www.banggood.com/4A-To-6A-24V-Switching-Power-Supply-Board-AC-DC-Power-Module-p-969204.htmlhttps://www.banggood.com/AC-DC-Switching-Power-Supply-Module-AC-100-240V-to-DC-24V-9A-Power-Supply-Board-p-1086527.html
1 x round switch for mains
2 x mini rectangular switch
1 x digital ammeter
1 x GX12 RS765 aviation plug with 2 or 3 pins for TS100
1 x T12 STM32 2.1S OLED
1 x TS100
1 x 2 core silicone cable and DC jack for TS100 DYI cable
Cable for wiring
4 x M3 8mm Self trap screws for psu
4 x M3 galvanic square nut
4 x M3 machined screw
Note: NxTS100 outputs will only have mains power switch, since irons can only start heating by a press of a button on the iron itself, so no need to make the plate more populated and expensive. Aditional you can easy unplug the DC jack from iron if you do not use it...
As a good rule if your team need to use multiple irons at same time please reserve 2.5A per output, 4/6A will feed 2 active irons and 6A/9A will feed 4 irons. But even a weak PSU can work well because irons only peak while cold boot. If your psu can't give the needed amps irons will heat up less quicky.
14/07/2018: 5mm width added to station and plates to allow more clearance and the new dual OLED T12 front plate.
Add NOTEXT version to allow clean results with larger nozzles
Station_top upper walls modified to spare plastic, less height and more robust design
13/04/2018: SMALLER version added, it reduce case lenght from 160mm to 150mm and height from 65mm to 40mm, it will save about 30% compared with normal version (+/- 2.5h less), a perfect solution for who want only the TS100.
SMALLER_xxx.stl's are not compatible with non smaller versions, print one or another but do not mix them
Timelapse: https://youtu.be/p505Rq6WJHY