Thingiverse
TS100 Soldering Iron Holder adapter by Ohmwrecker01
by Thingiverse
Last crawled date: 5 years, 4 months ago
This will adapt a Harbor freight soldering iron holder/ helping hands to hold the TS100 soldering iron. it is meant to be a tight fit that is lightly sanded with a dremel to fit snugly as desired.
you should use a higher temp plastic, I used PETG. I also lined the bottom with aluminum foil tape just incise i miss putting the soldering iron in so it will not gouge the plastic with the tip. its not necessary but suggested. because of the added thickness from the tape a little more than usual sanding was required. easy work for a dremel.
the whole thing is held in with 3 small zip ties to the metal spring guide.this design will also prevent the end of the iron from pokeing past the metal guard or even making contact with that guard.
-no supports
-infill 20%
infill is not important if you have thick walls. I used 5 line thick walls with no issues
you should use a higher temp plastic, I used PETG. I also lined the bottom with aluminum foil tape just incise i miss putting the soldering iron in so it will not gouge the plastic with the tip. its not necessary but suggested. because of the added thickness from the tape a little more than usual sanding was required. easy work for a dremel.
the whole thing is held in with 3 small zip ties to the metal spring guide.this design will also prevent the end of the iron from pokeing past the metal guard or even making contact with that guard.
-no supports
-infill 20%
infill is not important if you have thick walls. I used 5 line thick walls with no issues