Tronxy X5S E3D V6 Base Plate (Re-mixed) by printerDave

Last crawled date: 3 years, 1 month ago

Still new to CAD work, and isn't the cleanest but seems to work for me as a start.
Printed with PETG, 50% infill, flat backplate side on the bed, and used supports.
Has some mesh error in the slicer which I didn't see in Blender that shows up on the fan section. Haven't come back to clean it up yet ...
Remixed starting from jebk thing:https://www.thingiverse.com/thing:2638792
Clamp added directly here for E3Dv6.
Liked the design he put up but needed some adjustments for what I wanted.
Matched the X-axis end stop up to be the same location as original, and added a SN04 auto-level mount. Also wanted more clearance from the bottom carriage wheel relative to the Z axis.
UPDATE:
Created a new base plate that cleaned up the mesh error around the fan. Also added a belt alignment feature built in on the right hand side, and a bolt on add in for the left hand side.
Belt alignment was added as I used graham01's mega gantry plate;https://www.thingiverse.com/thing:2594291
The consolidation of the bearings to one position created the belt offset, so between the new base plate (Tronxy_X5S_E3dv6_wBeltAlignment) and the add on (Tronxy_X5S_BeltAlignment_LeftSide_AddOn) it should be lined up pretty well.
Also I'm using kawa18's original bearing pulley;https://www.thingiverse.com/thing:2610729
Here's my settings for probe offset using base plate with belt alignment;
//-----------------------Tronxy X5S SN04 sensor------------
define X_PROBE_OFFSET_FROM_EXTRUDER -45 // X offset: -left +right [of the nozzle]
define Y_PROBE_OFFSET_FROM_EXTRUDER 3 // Y offset: -front +behind [the nozzle]
define Z_PROBE_OFFSET_FROM_EXTRUDER 0 // Z offset: -below +above [the nozzle]
// Set the boundaries for probing (where the probe can reach).
define LEFT_PROBE_BED_POSITION 15
define RIGHT_PROBE_BED_POSITION 290
define BACK_PROBE_BED_POSITION 310
define FRONT_PROBE_BED_POSITION 15