Tronxy X3 x-belt tensioner by idig3d

Last crawled date: 3 years ago

The acrylic pulley mount for the x-belt left a lot to be desired on my Tronxy X3. The belt rubbed again the edge of the end of the extrusion rubbing of bits of rubber, and warped a bit with the belt a bit off kilter. Not good.
Reuses existing bits. Only needs an M5x25 screw and an M5 nut.
If you this helps and want to encourage my insanity, buy a cup of coffee for me, a bag of coffee, or you pick the value. Thanks!
A y-belt tensioner is available, too.
UPDATE: Changed the print orientation of the shaft part to hopefully ease installation. Modified the end cap with a slightly deeper lip and orientation arrows. Modified the knob to cover the screw end better. Included the new parts in the set.
UPDATE: Added a flatter endcap as a request by Budi.
UPDATE: Added a (hopefully) better design for the X1, but untested.