tRodgFPV SourceOne v4 30deg Camera Couch by 001010

Last crawled date: 2 years, 10 months ago

After several failed prints with TPU on other designs, and realizing that all of them are for other frame versions (not v4, which I needed). I reverse engineered the hole pattern and made my own. Enjoy!
My tried and true TPU for FlashForge Finder:
General:
Temperature: 210F
Layer Height: 0.20mm
First Layer Height: 0.20mm
Base Print: 30mm/s
Travel Speed: 30mm/s
Minimum Speed: 5mm/s
First Layer Max Speed: 15mm/s
First Layer Max Travel Speed: 15mm/s
Retraction Length: 4mm
Retraction Speed: 45mm/s
Perimeter
Shell Count: 2
Maximum Path Overlap: 50%
Start Point Mode: Closest
Permit optimized start point: Yes
Exterior Speed: 100%
Exterior Maximum Speed: 30mm/s
Visible Interior/Invisible Interior Speed: 100%
Infill
Top/Bottom Solid Layers: 3
Fill Density: 100% (make lesser to be lighter/weaker)
Fill Pattern: Line
Start Angle: 45deg
Cross Angle: 90deg
Overlap Perimeter: 70
Vase Mode: No
Solid Speed: 100%
Sparse Speed: 100%
Infill: All Defaults
Supports
None
Raft
No
Additions
Pre-Extrusion: Yes
Margin: 5.0mm
Path Length: 120mm
Speed: 20mm/s
Wall: No
Brim: No
Wiping Tower Speed: 60mm/s