Thingiverse
traxxas slash 2wd front suspension arms 3631 - Right and Left by QuantumFlexGate
by Thingiverse
Last crawled date: 4 years, 7 months ago
UPDATE: version 3 is ready for the field! - this version 3:
-adjusted the chassis hole position by 0.5mm for improved clearance and less sanding.
-reduced the cutout sizes for increased strength.
-increased the hole diameters by about 0.2mm.
Please post any breakages or improvement requests!
UPDATE: version 2 - another hour - this printed and is a usable version but required sanding around the chassis arms for free range of motion and to fit the pin through. I posted a jpg of the final product.
This is a draft part upon request. I only spent 3 hours on it, so it might work, it might not.
Be careful to print it with the flat side down and the cut-outs up.
This is designed in cm as units.
-adjusted the chassis hole position by 0.5mm for improved clearance and less sanding.
-reduced the cutout sizes for increased strength.
-increased the hole diameters by about 0.2mm.
Please post any breakages or improvement requests!
UPDATE: version 2 - another hour - this printed and is a usable version but required sanding around the chassis arms for free range of motion and to fit the pin through. I posted a jpg of the final product.
This is a draft part upon request. I only spent 3 hours on it, so it might work, it might not.
Be careful to print it with the flat side down and the cut-outs up.
This is designed in cm as units.