Thingiverse
Trackpoint Keyboard adjustable palmrest by penguin_holic
by Thingiverse
Last crawled date: 4 years, 8 months ago
This is a palm rest for Lenovo Trackpoint Keyboard (1st gen).
By moving the slider, you can adjust the angle of the keyboard.
The holes on the front and back of the keyboard hold it in place, so you can lift it up while it's attached.
The build surface is divided into left and right parts to make it possible to use a small 3D printer.
It is recommended to print the palm rest vertically to ensure a clean surface.
Body left x1
body right x1
Frame x2
Slider x2 Choose your favorite slider height from 15, 20, or 25
Peg_50 (Φ5.0) x7 Connects the body to the frame
Peg_55 (Φ5.5) x2 Connects the body to the keyboard
If the pegs are too tight or too loose, use the slicer to change the scale of the printout and adjust it.
By moving the slider, you can adjust the angle of the keyboard.
The holes on the front and back of the keyboard hold it in place, so you can lift it up while it's attached.
The build surface is divided into left and right parts to make it possible to use a small 3D printer.
It is recommended to print the palm rest vertically to ensure a clean surface.
Body left x1
body right x1
Frame x2
Slider x2 Choose your favorite slider height from 15, 20, or 25
Peg_50 (Φ5.0) x7 Connects the body to the frame
Peg_55 (Φ5.5) x2 Connects the body to the keyboard
If the pegs are too tight or too loose, use the slicer to change the scale of the printout and adjust it.