Tough IKEA 25mm Shelf Hanger Bracket by iotdesignshop

Last crawled date: 3 years, 1 month ago

I'm on an IKEA improvement kick this month! This is a slip on hanger that fits IKEA shelves that are 25mm thick. I designed this with robustness in mind to hold heavy coats.
The clamp is angled narrower at the opening to preload the plastic and allow the clamp to grab on firmly. The hanger hooks are thick, allowing for a variety of infill levels to tune strength of the part.
With a 30% hex infill and 4 shells, it holds two light jackets without any issue. If you pull heavily on the back hook, the clamp will open up, but it takes some work. And as mentioned, a bit more infill and shells would offset that.
It's designed to fit on the Makerbot Replicator class of build plate. Supports can be tricky, see the notes below.