TOTEM - Modular storage

Last crawled date: 6 years, 2 months ago

#DAGOCULTS

To put a little order on my desk, I designed this modular TOTEM: phone charging, compartments for all invasive "tricks", enough to store tools or pens, put a flower pot ...

The construction is simple: the trunk is a simple piece of curtain rod that can be found everywhere (Ø 35 mm) that must be cut (attention to the fingers!) To the desired length according to the number of modules we want to put (30 cm on the photos, but we can do bigger). A few wood screws and a little patience to print everything.

Each module can rotate thanks to the magic of 3D printing! There is a clearance of 0.35 mm. in the hinge: make sure your printer is accurate enough.
A small screw is required to secure the module to the desired height.

I use it on my desktop, but free to find your composition: storage of your 3D printer's tools, jewelery, aromatic plants ...

Each component is printable on a Ø 180 mm tray like the NEVA , or on all printers with a tray of this size.
No support ;-)
Average filling 15/20%

I can provide STEP or IGES files for those who want to make adaptations.

A small "LIKE" if you like this project.

Good print!