Thingiverse
Tippmann Phenom MCS Hurricane Mechanical Response Trigger Mod by troubadour3D
by Thingiverse
Last crawled date: 4 years, 4 months ago
These are the parts necessary to install a Tippmann response trigger in the mechanical frame for the X7 Phenom/MCS Hurricane.
This has been successfully tested at 20 bps with a magfed Hurricane and round ball.
I have not gotten it to work properly with X7 Phenom. The RT function works but the cyclone doesn't seem to get enough air. Might be a fun project for someone to tinker with.
It does work with the air tube in the grip.
You will need:
1x Tippmann 98 response trigger
A drill with 1/4" drill bit
A hack saw (the cylinder and pin of the RT are too long and will need to be shortened)
A set of needle files
A dremel (not required but it would be nice).
Installation video can be found here.https://youtu.be/0CaB5lZ8ceY
This has been successfully tested at 20 bps with a magfed Hurricane and round ball.
I have not gotten it to work properly with X7 Phenom. The RT function works but the cyclone doesn't seem to get enough air. Might be a fun project for someone to tinker with.
It does work with the air tube in the grip.
You will need:
1x Tippmann 98 response trigger
A drill with 1/4" drill bit
A hack saw (the cylinder and pin of the RT are too long and will need to be shortened)
A set of needle files
A dremel (not required but it would be nice).
Installation video can be found here.https://youtu.be/0CaB5lZ8ceY