Thingiverse
Tinyboy / Fabricator Mini 1.5 Part Cooling Fan by sinned6915
by Thingiverse
Last crawled date: 4 years, 1 month ago
Part cooling fan for TinyBoy Fabricator Mini. I got the idea from a part I saw here, but I did not save it and I can not find it now. If you know or are the original's author, please let me know so I can remix it right.
You will need to run an extra pair of wires and connect them to one of the free terminals on the board and reconfigure/recompile your firmware accordingly. .
The fan duct attached with the lower 2 screws of the hotend radiator fan. Its shallow and skinny to fit under the arms at Ymax and does not reduce Z travel.
You may need to reroute the heater and thermistor wires around every thing to clear the machine internals though.
I found it easier to .remove hot end to snake the wires through and in the wire bundle.
Tip: Print it on its SIDE without supports. The little bit that sags is inside and you wont notice it.
Depending on your additional fan, you might have to trim the fan duct a bit to get it to fit. The center tab should hold the fan in place.
You will need to run an extra pair of wires and connect them to one of the free terminals on the board and reconfigure/recompile your firmware accordingly. .
The fan duct attached with the lower 2 screws of the hotend radiator fan. Its shallow and skinny to fit under the arms at Ymax and does not reduce Z travel.
You may need to reroute the heater and thermistor wires around every thing to clear the machine internals though.
I found it easier to .remove hot end to snake the wires through and in the wire bundle.
Tip: Print it on its SIDE without supports. The little bit that sags is inside and you wont notice it.
Depending on your additional fan, you might have to trim the fan duct a bit to get it to fit. The center tab should hold the fan in place.